Redline Breakaway Switch w/Pin & Cable BA02-010. Reconnect the trailer cord to the tow vehicle. Redline 12 Volt Breakaway Kit w/LED Charge Indicator BA10-150. When testing is completed, re-insert the pin so it is flush with the switch body and the trailer brakes release. Double check by moving the tow vehicle forward, making sure the brakes are locked and operating properly.Ĩ. When testing the switch, disconnect trailer cord from the tow vehicle. Make sure the lanyard cable is not damaged and the battery is fully charged and maintained.ħ. Test the breakaway switch on a regular basis. Fasten the cable to the tow vehicle frame – Not on the safety chains or the tow ball.Ħ. Do not let lanyard cable drag on the ground. Push the pin back into the switch until the flange on the pin isįlush with the switch body. After the switch has been installed and wired in, pull the lanyard pin out of switch to make sure the brakes engage. Wire the breakaway switch as in wiring diagram.Ĥ. pull on the switch and will allow the switch to swivel.ģ. The breakaway should be bolted to the trailer frame with minimum 1/4” bolt that will accept a 75 lb. When the trailer becomes uncoupled during towing, the breakaway cable attached to your tow vehicle will pull the pin from the switch assembly, activating your. Make sure the tow vehicle can make sharp right and left turns without straining the lanyard cable.Ģ. There should be no strain or obstacles interfering with the lanyard cable connected to the tow vehicle. Built-in charger refuels the included rechargeable battery. Mount the breakaway switch on a horizontal plane as close to the hitch as possible. Breakaway system is designed to bring a trailer safely to a stop by activating its electric brakes should it become disconnected while being towed. Switch is installed according to the following procedure. Will close the circuit from the trailer battery to the brakes and put the brakes on.įor the breakaway switch to operate properly it is important that the trailer battery is sized to the brakes of the trailer, the terminals connections clean, the battery fully charged, and the When this happens the lanyard cable pin is pulled out of the breakaway switch and the switch The switch is designed to operate only when the towed trailer separates from the towing vehicle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |